Skip to content
zoroprint
Atsisiųsti

DTF heat press settings: temperature, time, pressure — and hot vs cold peel

A DTF transfer is finished in the press, not in the printer. Most “the print washed out” or “the edges lift” complaints are press settings, and the film you bought decides half of them.

6 min. skaitymo · Atnaujinta 2026-09-21
Trumpai
  1. Cure the powder fully (it must look like an orange-peel gel, not sugar)
  2. Press 15 s at 150–160 °C, medium pressure
  3. Peel according to the film type, then re-press 5–10 s with parchment

Starting point

  • Temperature 150–160 °C (300–320 °F). Polyester and blends at the low end, heavy cotton at the top.
  • Time 12–15 s for the first press, 5–10 s for the second press after peeling.
  • Pressure medium — about 3–4 bar on a pneumatic press, or “firm hand, not body weight” on a clamshell.
  • Always pre-press the garment 3–5 s to remove moisture and flatten seams.

Hot, warm or cold peel

The film manufacturer decides. Hot peel films release the moment the press opens; cold peel films need 20–40 s and will tear the design if you rush. Warm peel is the forgiving middle. If you do not know, peel one corner after 10 s: if the adhesive stretches like chewing gum, wait longer.

Second press

After peeling, cover with parchment or a Teflon sheet and press 5–10 s. This pushes the adhesive into the fibres, kills the plastic shine and is the single biggest factor in wash durability. For a matte finish use parchment; for a slight sheen use Teflon.

Per fabric

  • Cotton: standard settings.
  • Polyester sportswear: 140–150 °C, 10–12 s, to avoid dye migration and scorch marks. Test on a hidden area.
  • Nylon / softshell: 130–140 °C, light pressure, longer second press; some nylons need a low-temperature film.
  • Thick hoodies: raise pressure or use a pressing pillow so the seams do not lift the platen.

Įstrigai kitur? Klausk — ZoroPrint komanda atsako į kiekvieną klausimą.

Užduoti klausimą

Nauji DTF gidai tavo el. pašte

Maždaug vienas el. laiškas per mėnesį: nauji gidai ir vaizdo įrašai, sprendimai problemoms, apie kurias klausia žmonės, ir ZoroPrint naujienos.

Maždaug vienas el. laiškas per mėnesį su naujais DTF gidais, vaizdo įrašais ir ZoroPrint naujienomis. Pirmiausia el. paštu atsiųsime patvirtinimo nuorodą, o prenumeratos atsisakyti galėsi bet kada. Privatumo politika

Spausdink teisingai su ZoroPrint

Nemokamai vienam spausdintuvui. Kanalų testas, preflight ir baltas pagrindas iš šių gidų jau įdiegti.

Daugiau gidų