Skip to content
zoroprint
Laadi alla

DTF heat press settings: temperature, time, pressure — and hot vs cold peel

A DTF transfer is finished in the press, not in the printer. Most “the print washed out” or “the edges lift” complaints are press settings, and the film you bought decides half of them.

6 min lugemist · Uuendatud 2026-09-21
Lühidalt
  1. Cure the powder fully (it must look like an orange-peel gel, not sugar)
  2. Press 15 s at 150–160 °C, medium pressure
  3. Peel according to the film type, then re-press 5–10 s with parchment

Starting point

  • Temperature 150–160 °C (300–320 °F). Polyester and blends at the low end, heavy cotton at the top.
  • Time 12–15 s for the first press, 5–10 s for the second press after peeling.
  • Pressure medium — about 3–4 bar on a pneumatic press, or “firm hand, not body weight” on a clamshell.
  • Always pre-press the garment 3–5 s to remove moisture and flatten seams.

Hot, warm or cold peel

The film manufacturer decides. Hot peel films release the moment the press opens; cold peel films need 20–40 s and will tear the design if you rush. Warm peel is the forgiving middle. If you do not know, peel one corner after 10 s: if the adhesive stretches like chewing gum, wait longer.

Second press

After peeling, cover with parchment or a Teflon sheet and press 5–10 s. This pushes the adhesive into the fibres, kills the plastic shine and is the single biggest factor in wash durability. For a matte finish use parchment; for a slight sheen use Teflon.

Per fabric

  • Cotton: standard settings.
  • Polyester sportswear: 140–150 °C, 10–12 s, to avoid dye migration and scorch marks. Test on a hidden area.
  • Nylon / softshell: 130–140 °C, light pressure, longer second press; some nylons need a low-temperature film.
  • Thick hoodies: raise pressure or use a pressing pillow so the seams do not lift the platen.

Jäid millegi muuga hätta? Küsi — ZoroPrinti tiim vastab igale küsimusele.

Esita küsimus

Uued DTF-juhendid otse sinu postkasti

Umbes üks e-kiri kuus: uued juhendid ja videod, lahendused probleemidele, mille kohta inimesed küsivad, ning ZoroPrinti uudised.

Umbes üks e-kiri kuus uute DTF-juhendite, videote ja ZoroPrinti uudistega. Kõigepealt saadame sulle e-postiga kinnituslingi ja tellimusest saad loobuda igal ajal. Privaatsuspoliitika

Prindi õigesti ZoroPrintiga

Tasuta ühele printerile. Nende juhendite kanalitest, preflight ja valge aluskiht on sisse ehitatud.

Veel juhendeid