Skip to content

no white underbase is printing epson l805

asked 11 views

Trying to setup printer but no white underlay is printing. Channel mapping is correct, interestingly though, if I change to white only, it will print the underlay. Is there a particular setting that I need to change

Epson L805
Paul Basdenasked

2 answers

ZoroPrint adminZoroPrint team✓ 1 solutionanswered

Hi Paul, thanks, the detail about "white only" printing the underlay helps a lot, because it narrows it down.

In underbase mode ZoroPrint splits the head: colour prints from the nozzles that reach the film first, white from the ones after, so the white lands on top of the colour. In "white only" every nozzle prints white. So when white shows in "white only" but not in underbase, the usual cause is that the part of the head used for white isn't firing.

  1. Run a nozzle check (Printer tab → Nozzle check) on film or dark paper and look at the white channels. If lines are missing, run a head clean (white settles and clogs more than the colours) and check again.
  2. Check the Layer column in the channel table (Printer tab): the white channels should say "2 · white", all the colours "1 · colour".
  3. Quick test: set Layer order to "Colour and white together (fast)" and print the same design. If the underlay appears, it points to the nozzles (step 1).

If it's still missing after that, please send a photo of the nozzle check and the diagnostics file (Help → Save diagnostics for support) to hello@zoroprint.com, and we'll look at your exact settings.

Paul Basdenanswered

I had a blocked nozzle. Is there a way of putting more white down. I have white density at 100% but because my designs are going on Hi Visibility coats, I need to have a thick white underbase

  • Glad it was just a blocked nozzle, Paul!

    White density at 100 % is already the maximum for each dot, so to lay down more white:

    1. Print quality → 1440 × 1440. That puts down twice as much white as 1440 × 720. It prints slower and the ink takes longer to dry, so give the powder and curing a bit more time.
    2. In the white settings, keep Soft hand and Less white under dark colours at 0, because both remove white.
    3. Hi-vis coats are usually polyester, and the fluorescent dye can bleed into the white when you press. If the white looks tinted after pressing, a thicker white won't fix it. A blocker powder and a lower press temperature will: DTF on polyester: stopping dye migration

    Let us know how the first coat comes out.

    — ZoroPrint admin · ZoroPrint team ·

Your answer